If your 2013 Audi A6 uses a direct system, resetting the tire pressure sensors may be as simple as pushing a reset button on the dash or following a menu as indicated in your owner's manual. If your 2013 Audi A6 uses an indirect system, the system must be reset using a magnet or scanning tool by either a dealer or one you have bought yourself. A4, S4, A5, S5 and A6 only l A4, S4, A5, S5 and A6 only Fuel Filter – remove water l Audi Q7 3.0L TDI only – replace l 55K only: A3 2.0L TDI only l Audi Q7 3.0L TDI only 115K only: A3 2.0L TDI Diesel Particulate Filter (DPF) – check ash loading according to manufacturer’s work procedure, replace* if necessary. l 125K only: Audi Q7 3.0L TDI, How to enable TPMS (Tyre Pressure Monitoring) with VCDS on Audi Q5. This setting is available for almost every audi models.The ABS unit exist in two versions One of the main reasons for a TPMS malfunction in your Audi is a faulty tire pressure sensor. These sensors are located in the tires and are responsible for monitoring the air pressure within each tire. If the sensor becomes damaged, inaccurate, or fails completely, it can cause the TPMS warning light to illuminate on your dashboard. Press and hold down the reset button (sometimes located under the steering wheel) until the low-pressure light blinks three times. Release the button. Start the vehicle and let it run for 20 minutes to let its computer recalibrate each sensor. Turn off the ignition. 3. You find 03159 (tire pressure monitoring in ESP function) stored in the ABS control module, J104 (address word 03), without other DTCs. Here are the fixes for each scenario. The “TPMS” message, by itself, is NOT due to low tire pressure. The message only means that the tire pressure monitoring system (TPMS) is not active. Service reminder indicator display - Reset display Spare tire - Check condition and tire inflation pressure, adjust if necessary (if equipped) Spoiler - Lubricate rear spoiler (TT, TT Roadster only) Sunroof systems - Check function (if equipped) Tires - Check condition and tire tread wear. Check and record the tread depth Disconnect the Battery: In some cases, disconnecting the battery and reconnecting it can resolve the TPMS malfunction. This may reset the system and clear any temporary issues. However, if the issue persists, further troubleshooting is required. Check Tire Pressure: Ensure that all tires are properly inflated to the recommended PSI. How to reset the Audi Q7 tire pressure monitoring system (TPMS) light Audi A6. 35-38 psi. 38-41 psi. Are you overpaying for car insurance? Compare and find out in boN3.

audi a6 tyre pressure reset